Tools are used every day in every industry. They make small tasks easier and large tasks possible, but they're often taken for granted. Whether they're simple hand tools, or more complex power tools, all tools can pose a hazard in the workplace. Most of the time, hand and power tools can be used with no problems --but serious injuries can occur when tools are not properly maintained or they are not used correctly. Take steps now to identify and correct potential tool-related hazards in your workplace. Do you see what is wrong in this picture? 1. Non-insulated hand-tool must not be used for work on electrical box. OSHA says at 1910.335(a) (2)(i): "When working near exposed energized conductors or circuit parts, each employee shall use insulated tools or handling equipment if the tools or handling equipment might make contact with such conductors or parts. If the insulating capability of insulated tools or handling equipment is subject to damage, the insulating material shall be protected." 2. Improper use of tool OSHA says employers should establish safe working procedures. Five basic safety rules OSHA recommends to prevent hazards associated with the use of hand and power tools: * Keep all tools in good condition with regular maintenance. * Use the right tool for the job. * Examine each tool for damage before use and do not use damaged tools. * Operate tools according to the manufacturers' instructions. * Provide and use properly the right personal protective equipment. 3. Employee is not wearing personal protective equipment. OSHA says at 1910.335(a) (1)(i): "Employees working in areas where there are potential electrical hazards shall be provided with, and shall use, electrical protective equipment that is appropriate for the specific parts of the body to be protected and for the work to be performed. Note: Personal protective equipment requirements are contained in subpart I of this part." 4. Employee is wearing a conductive article of jewelry OSHA says at 1910.333(c) (8): "Conductive apparel." Conductive articles of jewelry and clothing (such a watch bands, bracelets, rings, key chains, necklaces, metalized aprons, cloth with conductive thread, or metal headgear) may not be worn if they might contact exposed energized parts. However, such articles may be worn if they are rendered nonconductive by covering, wrapping, or other insulating means. 5. Lockout/Tagout not performed.
0 Comments
Leave a Reply. |
AuthorI'm Bruce O. Pratt, who thoroughly enjoys researching about Power & Hand Tools. I hope my reviews can help you to choose the right products fit with your needs. Archives
November 2017
Categories |